Page 406 - Mechanical Products Installation Handbook IH-1000M

398 PREPARATION EQUIPMENT Rolled Groove Standard Specifications
For Steel and Other IPS Pipe
A Nominal B T Pipe Size
(1 of 2)
Tolerance C DN+-
MAX. OD FLARE
D
1. The maximum allow- able tolerances for IPS pipe from square cut ends is 0.030˝ (0.76 mm) for sizes 1.25˝ to 3˝ (DN32 to DN80); 0.045˝ (1.14 mm) for sizes 4˝ to 6˝ (DN100 to DN150); and 0.060˝ (1.52 mm) for sizes 8˝ (DN200) to 24˝ (DN600).
2. Gasket Seating Surface “A” must be free from score marks, ridges, in- dentations, projections, loose paint, scale, dirt chips, grease, rust, etc. that would prevent a pos- itive seal.
3.Groove diameter “C” must be of uniform depth around the circumference of the pipe.
4. Groove Depth “D” is a reference dimension of the distance from the pipe outer surface to the groove bottom, with re- gards to groove concen- tricity about the pipe. This dimension is a ref- erence only. The actual dimension “C” must be maintained.
5. Minimum Wall Thickness “T” is the minimum wall thickness that should be roll grooved.
6. Maximum allowable pipe end flare diameter is measured at the pipe end diameter.
ANSI Inches
Pipe O.D. Inches mm
O.D.
16
400
16.000
406,4
0.063
1,60
0.031
0,79
18
450
18.000
457,2
0.063
1,60
0.031
0,79
20
500
20.000
508,0
0.063
1,60
0.031
0,79
24
600
24.000
609,6
0.063
1,60
0.031
0,79
Refer to Tech Data Sheet G710 Groove Specifications for Steel Pipe.